Andyzell
Well-Known Member
How would you go about removing dents from a finish panel? i want to do something while i save up for the bonded title.
patience....ice....dolly hammer, dies.....and LOTS of patience.
Aluminum is very soft, so it heats up when you work it (thats what the ice is for....work the finish panel while cold...and work it SLOWLY, time IS of the essence with aluminum....and it wont distort as bad if you use thermal common sense.)
A buddy of mine just bought one off of a guy for like $150 that was mint. the guy didn't know he was sitting on a gold mine. His original one is in near mint condition. just needs polishing and paint. I'll ask him if he's willing to part with it.
http://www.totallyautoinc.com/paints.html I found this a while back..... DTM
Andy, please do yourself and your finish panel a favor and practice a LOT on something else first that isn't so important ... or as expensive to replace.