Not the best but this was right after I installed the rad and fans. Hadn’t even hooked up hoses yet.
View attachment 1715570324
So, Im not happy with the look of the trimmed fan. Just doesn't look very professional to me for a fairly high quality build. At the end of the day the best plan will be to shorten the WP by 3/4" This has already been done by another board member so it's all figured out. I'm drop shipping a new FlowKooler pump to Kellogg Automotive in AZ. They're going to do the machine work and correct reassembly. I can shorten the pulley to suit and I should be in business.
No, I'm shortening the nose and shaft, water side stays the same.I milled 1/4'' of mine to allow for the motor plate , 3/4'' sounds like it excessive to me , would it hinder waterflow ??