gen3 hemi question

[Black 69 Dart]

How many of you actually had to run the addapter or spacer for the hemi to a 727 or 904?




__________________

 

[hemijoejr]

As far as I knew that was old technology before formed flex plates when all you could get was a flat plate and it needed to be spaced out for converter clearance. I don't run one. No need to.

 

[joeboy]

Hemi Joes right, old tech... I have the flex plate for the swap, no spacer needed...

Joe

 

[Black 69 Dart]

Which flex plate are you guys using?

 

[4speeds4me]

Which flex plate are you guys using?

I believe this is what you're looking for...

 

[mo-cars]

A&A Transmission sell one , pn AA753 , $85 in there 2010 Catalog , looks the same as ATI's .

 

[Black 69 Dart]

I have the ati but it is very tight going on at converter bolts anyone else experience this?

 

[Rat Patrol]

I run a MP plate - no spacer required

 

[mo-cars]

I have the ati but it is very tight going on at converter bolts anyone else experience this?

Not sure I understand , can you explain further .

 

[Black 69 Dart]

It's tight to get all the bolts in like the bolt holes circle is off by a fraction.

 

[wade]

hey where abouts in edmonton are you located?

 

[mo-cars]

For me the convertor to flex plate bolts line up perfect , I'm using a 904 .

I think you will already know this , There is one offset hole . so it will only fit when the offset is matched between the two parts .

 

[Black 69 Dart]

I know about the offset hole, once the pattern lined up, best I could get it, the holes were still tough to start the bolts.

 

[Black 69 Dart]

Wade just north of the city by Gibbons.

 

[mo-cars]

I know about the offset hole, once the pattern lined up, best I could get it, the holes were still tough to start the bolts.

Hmm strange , round file maybe .