BARRACUDA340S
Well-Known Member
for now anyway! I ordered new shafts monday from Scott Brown and they didn't show up as of 6pm last night so I went ahead and used the old shafts for now. I made sure I had clearance for the oiling hole on the shaft and then fired it up. What a miracle, I had oil up top now :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll:
When I get the new shafts I'll have to do it over again but at least I can make the dyno tues and now I know what the problem was.
Sum Bich runs hard. It's a turd until about 4500 rpms then all kinds of sh$t starteds happening :shock: :shock: :shock:
I need to get a good tune up on it and then we'll see.
When I get the new shafts I'll have to do it over again but at least I can make the dyno tues and now I know what the problem was.
Sum Bich runs hard. It's a turd until about 4500 rpms then all kinds of sh$t starteds happening :shock: :shock: :shock:
I need to get a good tune up on it and then we'll see.
