[WANTED] Heater bezel nuts

[wilb68]

Im looking for those pesky little stamped steel nuts that screw on the plastic nubbys that hold the bezel to the dash.

Thanks for looking at my post

 

[cudamark]

Are you talking about the nuts for the defroster vents on top of the dash panel?

 

[niceolddart]

I think I have a few. They have a sharp edge on them that cuts into the plastic nubs when you install them correct?
I think there are a couple different sizes, so I need to know exactly what they're going on. Measuring the O.D. would help a lot too.

 

[wilb68]

Are you talking about the nuts for the defroster vents on top of the dash panel?

No they hold the woodgrain bezel around the heater controls

 

[wilb68]

The diameter of the pegs are .215 OD

 

[wilb68]

Nice old dart you have the right idea. I need 6 of them. They are really thin

 

[niceolddart]

I will check my stash & be in touch before the end of Sunday with pics of what I have, good enough?

 

[wilb68]

Perfect thank you for even taking the time to look.

 

[69FBCuda]

This ?

1970-72 Oldsmobile Side Marker Light Speed Nuts 8pc

1970-72 Oldsmobile Side Marker Light Speed Nuts 8pc

www.inlinetube.com

 

[wilb68]

Only without the washer like flange.

 

[wilb68]

Like this only smaller

 

[69FBCuda]

Closer
www.rtspecialties.net/proddetail.php?prod=1000525

1003400 EMBLEM NUT 1/8 STUD X1/4, HARDWARE, 1003400 :Mopar Fasteners, Clips & Hardware

www.rtspecialties.net

 

[wilb68]

69fbcuda the 1st ones just might work.
Thank you

 

[Murray]

R/T Specialties.