I have two Holley 3310 carbs with the secondary metering plates. Can i replace the plate of one with the primary metering block off the other, so that i can adjust the jets if needed? I know summit racing has a kit for about $50.00, but times are tough. thanks
Holley Guru Needed
- Thread starter moparguy
- Start date
-
chasduster
Well-Known Member
someone will chime in......hey can someone help out this member..please
Do it. it will work
terry
Well-Known Member
yes you can use one block to replace a meter plate. i agree much nicer for tunning secondaries
terry
terry
pettybludart
Well-Known Member
I,m running the 3310,and have to say this is a very overlooked carb.Yes,play with it and be shocked at the performance.My 2.
chlngr1970
Well-Known Member
I have a 3310 on my Duster. They make a metering block kit that comes with the block, gaskets and screws needed to install it. The secondary metering block has no provision for a power valve. I don't know about the jets. Mine has 4 different jets in it. The primary side has 70 and I think 75, the secondary has 73 and 77. I have NO idea why. I'm trying to find a good starting point for installing jets and tuning my carb. :dontknow:
j
j
-
