[SOLD] Hughes Cam and Timing Set NEW

[thomasfouraker]

Both brand new never used.

Cam never removed from wrapper.

Timing gear removed for photos.

Hughes 6440 Timing Set $70 plus $10 shipping.

SER2226ALN-10 $380 plus $20 shipping.

Both for $450 shipped.

Located in NE Florida.

 

[thomasfouraker]

Both brand new never used.

Cam never removed from wrapper.

Timing gear removed for photos.

Hughes 6440 Timing Set $70 plus $10 shipping.

SER2226ALN-10 $380 plus $20 shipping.

Both for $450 shipped.

Located in NE Florida.

 

[migsBIG]

is that cam street, strip, off road spec?

 

[abodyjoe]

is that cam street, strip, off road spec?

Basic guidelines (These are not absolutes, just guidelines to help you get close on a cam choice)
Use: Hot street, works well with performance heads and high flow throttle body/carb, upgraded injectors a/r
Idle: Noticeable
Vacuum: mid-range
Converter: Stock to mild stall
Rear gear: Stock to 3.55
Benefits:420HP potentiel at flywheel
Requires a ECU re-programed for magnum engines

 

[thomasfouraker]

is that cam street, strip, off road spec?

I would say it’s pretty street for a 318/360. If you put it in a stroker it would act a little smaller and the curve would start lower. You can call Hughes with your engine specs and they could give you a good idea how the cam will behave.

 

[DARTLARRY]

Is this too much lift for stock pistons?

 

[thomasfouraker]

Is this too much lift for stock pistons?

Not on a magnum. Valve springs need upgraded for factory magnum heads though.

 

[TT5.9mag]

I’ll take the cam if you’ll separate. PM me please

Edited to add;
I PM’d you

 

[thomasfouraker]

I’ll take the cam if you’ll separate. PM me please

Edited to add;
I PM’d you

PM Sent. Sale pending on CAMSHAFT ONLY.

 

[TT5.9mag]

PM Sent. Sale pending on CAMSHAFT ONLY.

You can consider the cam sold gentlemen.

 

[thomasfouraker]

Cam is SOLD

Timing Gear is still available.