Is it possible to have my top radiator hose moved?

[USCG CHARGER]

I have this radiator and want to change my engine from a LA360 to a new Hemi IIIGen. If I want to use the car accessories then I need to have the top outlet of the radiator moved, or is that even possible? Do I just take it to a radiator shop and tell them what I want? Here is a pic of what I have.
http://www.forabodiesonly.com/mopar/attachment.php?attachmentid=137637&stc=1&d=1269127764

 

[pettybludart]

Any good rad shop should beable to swap the top tube outlet for you.JMO.

 

[RustyRatRod]

Yup old Scott is right on the money. Those hose necks can be put most anywhere.

 

[Mad Dart]

Piece of cake!!

 

[dgc333]

Slow down there guys! The radiator he has is aluminum, he will need to find a shop that can weld aluminum, most of the radiator shops I have delt with over the years only work on copper units that they can solder.

 

[rjsjea]

Might be a wash to sell the brand new one in the pic and buy the right one with the left side outlet/inlet. Unless you find a shop that will do it for reasonable $$

 

[66cuda]

Slow down there guys! The radiator he has is aluminum, he will need to find a shop that can weld aluminum, most of the radiator shops I have delt with over the years only work on copper units that they can solder.

ok well that may be the case where you are ...but with the advent of the newer radiators being alum & plastic MOST in the metro Detroit area can service either/both Copper/ALum...moving that neck should not be a stumbling block for any sizable rad shop...esp one that does custom rads since most of them are all alum