Snake
Mopar Nut
Looking to buy lca stiffing plates,does anyone know wear in Canada i can get them.Thanks.
LCA STIFFING PLATES.
- Thread starter Snake
- Start date
-
71DodgeDemon340
Well-Known Member
I know they should be available, cant remember where i got mine. Could make your own, they arent too complicated, but its nice to be able to weld em in and not fabricate your own
They may ship to canada
Lower Control Arm Stiffening Plate
Mancini Racing Lower Control Arm box Plates
They may ship to canada
Lower Control Arm Stiffening Plate
Mancini Racing Lower Control Arm box Plates
RBConvert
Well-Known Member
Got mine from PST - they're also a vendor on this site.
That' where I got mine from. No complaints other than my shitty welding.
Cuda68Scott
Well-Known Member
Rustyfish
Member
Nice welds!
Snake
Mopar Nut
on order thanks all.
Ok...so side-question here: I don't doubt that these are necessary and helpful but how does lower control arm flex show up? Can you guys feel it?
At what level of performance do they become important?
Do they ever fail or is it just a matter of alignment wandering under hard cornering?
Where should this mod fall in the order of reinforcements (torque boxes, subframe connectors, etc)?
At what level of performance do they become important?
Do they ever fail or is it just a matter of alignment wandering under hard cornering?
Where should this mod fall in the order of reinforcements (torque boxes, subframe connectors, etc)?
Going to build my own,draw up a pattern and zip them off on my buddy’s cnc plasma table.
famous bob
mopar misfit
if, I WANTED SOME, I`D MAKE THEM. WOULD BE A LOT CHEAPER, AND LIGHTER !
I honestly believe if these arms twisted a lot we would have seen loose rivets at the ball joint end somewhere by now. Tying the to pieces together will prevent spreading at torsion bar pivot end. That we have seen. A couple small pieces of flat bar would do.
-
