LIFTER VALLEY Pan Small block

-
D

djwhog

Well-Known Member
Joined
Jan 22, 2007
Messages
1,600
Reaction score
6
Just want to get some feed back as to what most people are using for valley pans on small blocks and which models seem to fit the best?
 
If your are talking about the tray that goes in the lifter valley, I haved used the Moroso one in all my small blocks. I have always had to trim them to fit, due to different castings. It keeps the hot oil off the bottom of the intake. I like to use them to keep the lifter in place in case of a pushrod failure. If the lifter comes out , you will lose oil pressure.
 
Thats what bought for mine and I had to trim it. Only took me a minute and it fit fine.
 
Does the Milodon fit any better that Jegs list than the Moroso?

I have in the past made one but thought this time I would go the easy route and just buy one that would be a bolt in fit..
 
i run milodon and didnt have to trim it... its been 4 years now and no problems...
 
Mine was Mildon not Moroso. Got it from Summit. Just had to do some light trimming. I had to grind the edge a little because the opening for the pushrod was almost hitting the pushrod.
 
You must log in or register to reply here.
-

Back
Top