LMAO HERE'S a deal killer!!!!

[67Dart273]

http://spokane.craigslist.org/cto/5263359909.html

1976 dodge step side first year - $1500 (spokane

1976 dodge step 2 wheel drive side short bed 318 strong but found out it has Chevy back fenderz.smallquarter size hole in bed behind driver side.few miner rusts spots.just replaced brakes on front windshield wipers tires front two front $120 200 for tittle and tabs 100 for trade for newer Chevy truck asking 1500 obo runs drives great for how old it is.d.miner problems fixed perfect work truck I used it for lawn service for 3yrs did good. just call for more info...

 

[67 Power Wagon]

-I'd take it, Aftermarket replacement fender shouldn't be that difficult to get..... and for $1500 well as you SEE it now, it needs work, what doesn't need work at its age, for the price?

-Juss sayin' I'd buy it if I had it as then I could restore it as I wanted it to be. stock, BUT lookin' good, its a good base for 15 hundred!

 

[RustyRatRod]

Some of those trucks came from the factory with those fenders.

 

[67Dart273]

Some of those trucks came from the factory with those fenders.

You mean Ma bought fenders from GM or whoever?

 

[RustyRatRod]

Yes. Hotlines has or had one. It was a factory truck with those same fenders. I have seen others too.

 

[Princess Valiant]

still American back fenders .....I would drive it ....as long as the tail gate says "DODGE" then there is nothing wrong with the whole truck as it is.

not a bad price either.

 

[Abodybomber]

Buy it,slam it, huffer through the hood,baby!

 

[ssba]

I'm not buying the rear fenders being original.
Easily fixed, could be cool.

 

[furyus2]

I'm not buying the rear fenders being original.
Easily fixed, could be cool.

Sounds like a load of crap to me too.

 

[67cudafb]

I would go over the whole truck with a magnet. Those trucks had a lot of rust problems. Check the leading edge of roof on the passenger side. My neighbor has three of that vintage and two have big holes in the roof. That one looks like has rust in right front fender. I would be more concerned with rust than the rear fenders.

 

[67 Power Wagon]

Can't say it be a deal breaker for me tho.... I'd buy it, and make it whatever the hell I wante3d too...... as I mentioned tho, replacement re-pop fenders really that difficult to find? Nevermind price for them shouldn't be to bad, we're not talkin about a '71 Cuda here and needing a shark tooth grille replacement!!!!!

 

[dozer556]

Can't say it be a deal breaker for me tho.... I'd buy it, and make it whatever the hell I wante3d too...... as I mentioned tho, replacement re-pop fenders really that difficult to find? Nevermind price for them shouldn't be to bad, we're not talkin about a '71 Cuda here and needing a shark tooth grille replacement!!!!!

I've only seen them offered in fiberglass, and they are not cheap at $265...each.

http://www.dodgeconnection.com/page/page/2821586.htm

I haven't found anyone re-popping these in metal.

You might be able to turn some up in junk/wrecking yards, but you know how that goes.

 

[67 Power Wagon]

-Right but that is.... if you (or the buyer) can't handle that the ones on it are in fact GM instead of Ma Mopar.....

I'd buy the re-pops, if I was being that anal and none were to be found in a yard......

 

[YY1]

Nice to see it has new wiper brakes and the miners are now mining correctly.

76 NOT the first year of anything on that truck unless it has an 833 OD (not even sure about that).

I've got a set of rear fenders but shipping would be killer to CA.