Lil Demon
Well-Known Member
I'm using the Milodon 30936 for my 340 on a 1971 Demon. Stock K Member and Hooker competition headers. Anyone have any experience with this oil pan and whether anything had clearance issues? Thanks!
Milodon 30936 clearance issues?
- Thread starter Lil Demon
- Start date
-
that oil pan usually hit the k member on the passenger side...k member needs to be notched...
I used hooker 5204 1 3/4 headers and they hit the driver side rear of the sump...hammer time...
I used hooker 5204 1 3/4 headers and they hit the driver side rear of the sump...hammer time...
MOPAROFFICIAL
Oogliboogli
Ditto. Lop the front passenger corner off like a 2 inch triangle and welded flat plate over it. On the drivers sump cut a line where it kicks out a hair,hammered it in to close it up and dropped a bead over it...and btw it hits 1 5/8 Hookers as well.
Lil Demon
Well-Known Member
Thanks for the heads up guys!
Thou I'm using a RMS K-member, I to had to notch my oil pan. Here is the link showing what I did.
RMS in a 68 Barracuda, oil pan problems
RMS in a 68 Barracuda, oil pan problems
-
