[SOLD] Mopar A body 4 speed

[jtkaaa07]

Rebuilt A body 4 speed correct for any A body ,Dart, Duster, Barracuda, Demon etc from 64-76. This is a standard 4 speed, NOT the overdrive version! Has the 4.35 bearing retainer on input shaft. Has the 26 spline output shaft . Freshly rebuilt transmission was completely disassembled cleaned and inspected, with all new bearings synchronizer rings, slider keys and springs, and seals. This is not a spray can rebuild and is in absolutely excellent condition, and ready to install! Asking $750 plus the ride, which is normally around $130-150 anywhere in the continental U.S.A.. Located in Central Wisconsin

 

[jtkaaa07]

$700 plus ride

 

[Ed Jackson]

Would you take 750 shipped?

 

[Ed Jackson]

where did you get that yellow plug for the rear seal? i am guessing that will retain the fluid during clutch swaps? thanks for the info

 

[duster360]

What is the first gear ratio?

 

[davescuda]

small yoke or lake yoke?

 

[jtkaaa07]

where did you get that yellow plug for the rear seal? i am guessing that will retain the fluid during clutch swaps? thanks for the info

It's a pvc pipe cap, painted it yellow so you don't forget to take it out

 

[jtkaaa07]

What is the first gear ratio?

I believe it's 3:09

 

[jtkaaa07]

Sold pending payment

 

[pomonamissel]

26 spine output shaft is the small /6 or two bbl v8 type .