Need 8 3/4 center section

[Sinister.]

Looking for either a 3.55sg 8.75 center section, or 3.55 gears(741) and a suregrip unit.

What cha got?

 

[Sinister.]

Anyone?

 

[Sinister.]

I'd hate to have to buy new... it's so expensive.

 

[Relax360]

I have a bare 489 case if your interested.

Brad

 

[Small Block]

Hey 360, how much for your bare 489 ?
Small Block

 

[Sinister.]

Not interested in a bare case at this time

 

[Sinister.]

The search continues...

 

[cudamark]

I've a 3.55 S.G. in a 489 case with the 2 1/8" u-joint. I'm waiting for two other guys to decide if they want it or not. If they pass, I'll let you know. Shipping might be an issue though as they weigh about 85lbs. Where are you?
Thanks, Mark

 

[Sinister.]

I'm very interested. I can cover shipping. I'd like to get it as soon as possible so let me know what those other guys decide. How much are you asking for it?

 

[Sinister.]

Oh yeah, and I'm in Eastern Kansas

 

[Sinister.]

Any word from those two gentlemen on the pumpkin?

Anybody else find one laying around yet?

 

[Gregs70]

I ended up with a truck 8 3/4 in a part swap. It has a 741 case with the 3.55 tag on it. I rotated one axle and the other end went the opposite direction so looks like an open rear end. I'm in Cleveland, Ohio so shipping would be pricey. PM me if interested and I'll pull the pumpkin, check it out to verify it has 3.55s, and give you a shipping weight.

 

[Sinister.]

Would really prefer suregrip. If nothing comes up I may contact you and just buy a new suregrip unit.

 

[Gregs70]

No hurry. I haven't posted it anywhere yet except right here. BTW, eastern KS? I used to live in Ft. Scott...

 

[djwhog]

I have a 489 case 323 gears dog leg, sorry no posi... but can be made into one..

 

[340duster340]

i have 489 case with cone posi and 2.76:1, factor set and never messed with, from low mile cbody so not beat on either -- $300 + ship

489 case, all new clutch posi, new 3.91 gears, timkin bearings, ubolt yoke, solid pinion spacer $900 + ship

 

[Sinister.]

i have 489 case with cone posi and 2.76:1, factor set and never messed with, from low mile cbody so not beat on either -- $300 + ship

489 case, all new clutch posi, new 3.91 gears, timkin bearings, ubolt yoke, solid pinion spacer $900 + ship

I've got 2.76 in the 7 1/4 in the car, so that wouldn't be much of an upgrade, 3.91s are a little much, and out of my price range

Thanks for the offers, but I'm going to have to pass on both.

 

[Sinister.]

There must be one somewhere...

 

[flmopars]

I have a bare 489 case

 

[avarageerod]

I've got a 3.23 in a 489 case, suregrip. PM me if your interested