Need breakdown on door mechanism

-
MR.7DUSTER3

MR.7DUSTER3

His money, My time
Joined
Mar 30, 2006
Messages
615
Reaction score
7
Location
Anaheim, Ca.
Hey guys we are getting ready to put the side door glass and all the handles and door locks back in, i stripped it out when the duster went to the body shop,. I should have taken pics but didnt think it was going to take this long to put it back together. Is there any info or pics that would show me what goes where ?

Thanks,

bob
 
Ok since no one else has said it. I will throw it out there. The service manual has lots of good information on assembly.

I can tell you generals from my Barracuda. There are 4 components First is the regulator then the glass and the tracks (front and rear). Assemble the glass retainers leave glass out for now. Get the regulator in 3 or 4 bolts leave it loose. Jimmy it into the front track while placing it. Then slide the rear track into the "scissor" and place the rear track tighten it down. Then assemble the window into the hardware on the regulator.
 
Thanks guy,

anyone else got any hints on linkage and door rods ,i think i have glass and tracks covered now.

Bob
 
Cover all the sharp sheet metal edges with duct tape.
 
You must log in or register to reply here.
-

Back
Top