new TO bearing noise

[Darren]

Hey guys I just installed a new mcleod clutch kit plus new pilot and TO bearing. I just started the car (68 Cuda 383 ) and when I push in the clutch I get a little squeak but when the car warms up it goes away. Are these TO bearings greased from mcleod? Does anything have to break in? Any ideas? Thanks

 

[Marcohotrod]

they come greased, I would run it for a few days

 

[AJ/FormS]

Does it squeak as it begins to spin,only?
Or as it is moving forward to engage?

 

[Darren]

I am pretty sure it was making it only when the clutch pedal was pushed to the floor only.... I just went to start it the was no noise ( but engine was still warm) but I will try it later on tonight when the engine is cold.. thanks

 

[nm9stheham]

If it is a problem, you will hear some noise come back....TO bearing noises are pretty obvious if you pay attention.... as it seems the OP is.

 

[Darren]

Just went out to try the car and really smooth no noise... but I will keep a close eye (ear)on it.. thanks