no instructions for eagle rods

[abodyhotrod]

i have a set of h beam esp rods. the instructions only talk about torque specs not which way to face the rod. do any of you know. i think you put the bearing notches toward the outside.

 

[70dart340]

On stock rods, I believe the notch goes toward the center of the engine so it can squirt cool oil under the adjoining piston.

 

[abodyhotrod]

these rods dont have that oil hole in them. only the notches keep the baring in place.

 

[3404spdvaliant]

The beveled side go's outward to the radius or fillet depending on crank.
The flat side face each other.
The bolts which should be ARP 2000 torque to 72-75 ftlbs.
There are, as far as I know, oil holes[2] in the small end/pin end.

 

[68 HEMI GTS]

chrysler rods the tangs always go toward the pan rail, or like the post above you can look at the bevel.

 

[abodyhotrod]

i shall finish pistons and rods tonight thank you guys.
and yes your right 3404spdvaliant the small end has those two oil holes. thanks again