Parallel two barrel slant help

[Dartalltheway]

I need some help on the the parallel 2bbl conversion is setup. If anybody had pictures it would really help. I can't figure out how to get the throttle cable to fit properly. All help appreciated.

 

[Wolfy2U]

http://www.forabodiesonly.com/mopar/vbpicgallery.php?do=view&g=2857

Here are some picks of my super six conversion. I used the cable and pedal assy off my 76 Aspen. Built a plate for where the shaft went through the firewall. Don't know if this will help or not.

 

[Dartalltheway]

I was searching and I think I got the wrong terms on here. It is an intake that has a parallel opening to the engine block. The linkage will be perpendicular.

 

[/6 Matt]

Are you talking about side draft carbs like these?

http://www.google.com/imgres?q=slan...199&start=0&ndsp=16&ved=1t:429,r:15,s:0,i:129

 

[/6 Matt]

No wait, I think I understand....

 

[/6 Matt]

It doesn't look like this:
http://www.google.com/imgres?q=slan...0&ndsp=18&ved=1t:429,r:1,s:0,i:87&tx=81&ty=62

But like these?
http://www.google.com/imgres?q=slan...=229&start=0&ndsp=18&ved=1t:429,r:6,s:0,i:102
http://www.google.com/imgres?q=slan...45&start=18&ndsp=21&ved=1t:429,r:25,s:0,i:165

 

[mcnoople]

I bet you mean this. Sorry the quality of the scan wasn't too great, but it is the first link I found to it.

[ame]http://u225.torque.net/cars/SL6/articles/Parallel_2bbl.pdf[/ame]

Keep in mind that the car used for the article does not use cable linkage, it has a throttle rod if you are using a cable you don't have to do the carb mods you just need the appropiate length throttle cable and kickdown cable setup.

 

[mcnoople]

here another one. Make sure to click the one red link on "61 v200"'s post it is right beneath his picture of a 61 plymouth. The link title is super six conversion stromberg.

http://www.slantsix.org/forum/viewtopic.php?t=28966&highlight=paralell+parallel+two+barrel

 

[Dartalltheway]

Those are exactly what I'm looking for, helped a lot thank you.