Purchasing a floor pan.

[adamm]

That's what I used on the rest of the under body and wheel wells instead of undercoat. You think that would be good on the top side too?

I really like how it turned out. Crazy how much it fades though from when I did the mid/rear vs the front. About 2 years in-between. As solid as you would expect a truck bed liner to be.

 

[moparmat2000]

AMD fit awesome in my 74 Dodge dart. Just finished the install. I also used a pneumatic hole punch, saves time!!

View attachment 1715370095 View attachment 1715370096

Those dont look like AMD to me. AMD usually finishes the panel including prepunching all the drain holes. I never seen AMD just make smaller patches for A bodys like that. Usually whole pan or full side.

 

[moparmat2000]

Ok, I have the floor installed. A couple little clips came with it. What are they for and where do they go?
View attachment 1715372544
Thanks for any insight.

Those are for the speedometer cable and reverse light wiring

 

[moparmat2000]

I have the cable stay welded on for the park brake. But don't see a use for these yet.
Getting the 4 spd all cut and fitted. Sure hated to cut that big hole in the new $500 bill. LOL

View attachment 1715372601

Got mine at summit on black Friday sale, then drove 3 hour round trip to get it. $369 on sale plus gas.

 

[adamm]

Those dont look like AMD to me. AMD usually finishes the panel including prepunching all the drain holes. I never seen AMD just make smaller patches for A bodys like that. Usually whole pan or full side.

I bought them direct from AMD, still have the stickers that came on them with my receipts.