Mgc340
Well-Known Member
358 ci ex Craftsman truck motor
3.310 billet stroke crank
Bore is 4.150
W8 Arrington heads
Complete with springs and rockers
Drysump oiling
598 Mopar intake
This motor was run and freshened a couple times after it’s nascar life. This was run in a circle track car. The cylinders look good. I pulled a couple main caps off last night and the crank looks awesome. I think a hone of the cylinders and some new rings along with main and rod bearings is all this engine needs. It’s been sitting for a little while in a shop and it’s dirty it needs a good scrubbing down. I plan on cleaning this up the best I can. If someone is seriously interested I can disassemble the motor. It’s complete from intake to oil pan.
I was told compression is 13:1
Motor should make close to 750hp.
Serious inquires only. I prefer to ship Fastenal hardware stores.
Please don’t ask me to hold this engine, cash is king I’m tired of tire kickers.
$6,500
3.310 billet stroke crank
Bore is 4.150
W8 Arrington heads
Complete with springs and rockers
Drysump oiling
598 Mopar intake
This motor was run and freshened a couple times after it’s nascar life. This was run in a circle track car. The cylinders look good. I pulled a couple main caps off last night and the crank looks awesome. I think a hone of the cylinders and some new rings along with main and rod bearings is all this engine needs. It’s been sitting for a little while in a shop and it’s dirty it needs a good scrubbing down. I plan on cleaning this up the best I can. If someone is seriously interested I can disassemble the motor. It’s complete from intake to oil pan.
I was told compression is 13:1
Motor should make close to 750hp.
Serious inquires only. I prefer to ship Fastenal hardware stores.
Please don’t ask me to hold this engine, cash is king I’m tired of tire kickers.
$6,500
