JasonR
Member
Car: '69 Dart Slant Six w/ factory air conditioning.
I'm working to get the AC up and running in my Dart, and just finished replacing some of the missing wiring. I have a question about the idler/tension pulley...
It is a single-v pulley with a cup washer and a seal for the pressed-in shaft bearing. Any idea if this is rebuild-able? I couldn't find anything in the service manual, and I can't seem to locate a replacement part for the whole assembly.
It is a bit stiff, but I'm about to go get a belt to put on it and in case it is shot I'd like to know where to turn. The heat is on here in AZ!
Cheers,
Jason
I'm working to get the AC up and running in my Dart, and just finished replacing some of the missing wiring. I have a question about the idler/tension pulley...
It is a single-v pulley with a cup washer and a seal for the pressed-in shaft bearing. Any idea if this is rebuild-able? I couldn't find anything in the service manual, and I can't seem to locate a replacement part for the whole assembly.
It is a bit stiff, but I'm about to go get a belt to put on it and in case it is shot I'd like to know where to turn. The heat is on here in AZ!
Cheers,
Jason
