Hello, getting ready to finish up the engine/transmission install on my 66 barracuda
I started working on the freshly rebuilt a904 - Because of multiple reasons - it has been boxed up for a couple months as I was getting ready for the swap - plus life getting in the way.
I was installing the linkage off my existing 904 - which came to a halt at the shift shaft. The top shaft has been cut off and smoothed - appears to have been done by design.
Hopefully I am missing something - I can not figure out how to install the kickdown leaver. And from my limited research, this leaver is also required for the lokar 2904 kit. Am I missing something?
Or do I need to replace the shift shaft and seal?
I started working on the freshly rebuilt a904 - Because of multiple reasons - it has been boxed up for a couple months as I was getting ready for the swap - plus life getting in the way.
I was installing the linkage off my existing 904 - which came to a halt at the shift shaft. The top shaft has been cut off and smoothed - appears to have been done by design.
Hopefully I am missing something - I can not figure out how to install the kickdown leaver. And from my limited research, this leaver is also required for the lokar 2904 kit. Am I missing something?
Or do I need to replace the shift shaft and seal?