[WANTED] Shift rods and levers
- Thread starter txas2step
- Start date
-
- Status
Good luck. The arms are the same Brewer's Performance - Mopar A833 4-Speed Transmission and Component Specialists. They are also the same as 64 to 67 "B" Bodies. The rods are very hard to find. You can usually use, may have to run a die and cut new threads farther down, a later "A" body reverse rod. You can also use Hurst 1-2 and 3-4 aftermarket rods since they used the basically same shifter and mounting plate as the 64-65 OEM Hurst shifters.
txas2step
Well-Known Member
Thanks, I actually have the 1-2 rod, looking for the reverse and the 3-4 or a whole set. Are the B-body or later A-body the same configuration but just a different length? No problem with shortening and threading if that is an option.
Last edited:
Buy my complete 65 A Body 833 setup and it’ll include all the rods and levers plus extras
"B" bodies rods are shorter by a lot, look at the mounting pad. The 64-65 mounting pad is rotated so the shift rods are shorter than the 68 up "A" body rods. It's good you only need the 3-4 rod then. I doubt a 68 up 3-4 rod could be made to work, but not impossible. Maybe get a used rod from another car and shorten and bend it to work. I'll take some pictures of my original 64 3-4 rod in the next day or two.
- Status
-
