[WANTED] Slant 6
- Thread starter Lonestarcorduan
- Start date
-
- Status
Assume you want a 225 cu. In. I have a 170 block that meets your requirements.
Lonestarcorduan
Member
Sorry, yes looking for a 225.
Charrlie_S
Well-Known Member
I should have a good early 225 std bore block, but I don't know if it would be cost effective to ship.
Lonestarcorduan
Member
Shipping would probably be expensive, I will check on that this week.
Charrlie_S
Well-Known Member
Just to clarify. You just need a empty block, is that correct?
Lonestarcorduan
Member
Yes, mine just has to many issues, easier to replace it.
- Joined
- Apr 16, 2009
- Messages
- 4,267
- Reaction score
- 6,086
I have a 225 located in fort Smith Arkansas.
About 5 hours from you.
Let me know if you may be interested,
It is a standard bore from an 84 D100 complete and has a auto tranny as well if needed,
About 5 hours from you.
Let me know if you may be interested,
It is a standard bore from an 84 D100 complete and has a auto tranny as well if needed,
Charrlie_S
Well-Known Member
Just a reminder 1977 up would be a cast crank block.
Lonestarcorduan
Member
Still looking, local to the DFW Texas area.
I'm just N of Houston 77371. About 4-5 hrs from Dallas. I have 2 std bore 225s. they turn over. Cores. Come with the 3 speed manual trans and bell. Both '62 motors.
Lonestarcorduan
Member
Are you looking to get rid of all of it? How much?
Yes//// I have another complte slant saved back to go in my 62 Lancer. The 225s are $150 each and the 3 speed trans with bells are $75. These are what I call cores as not running. I will not be using them so I would to see them go to a good home. Message me direct for my cell if intersted.
- Status
-
