small block dist. for sale

[stroker_valiant]

Distributor out of my stroker, it has about 1000 miles on it. I upgraded to an MSD Pro billet, so this one works just fine and has NO issues. It has the ignition module with it. I took the module out so I could run this with my 6al box, hooking it to the CD is very simple; two wires of the same color. The ignition module is a four post, I don’t remember which post gets which wire, but it wouldn’t be too hard to figure out. When I was running this one, timing would start to come in at 1000 rpm, and add another 10 degrees and be all in by 1700 rpm, so it has a very light swing. Cap and rotor have light wear, but still very usable. I have provided a link to the EXACT same distributor for a reference. Located in Tulsa Oklahoma, 74055 40 bucks plus shipping.

http://cgi.ebay.com/ebaymotors/PROC...r_Truck_Parts_Accessories&hash=item1e651a13e4

 

[stroker_valiant]

nobody wants a good unit?

 

[Charlie's Dart]

do you know the make of the dist ?

 

[Old Tired Rebel]

nobody wants a good unit?

I do but my car has other issues.

 

[stroker_valiant]

do you know the make of the dist ?

I'm soory, I didnt see your posting. It would be faster to pm me.
I do not know the brand of the dist, but the box it came in has a part number of WP8913M, PRO billet ready to run chrysler. That is just what the box says.

 

[stroker_valiant]

Actually, I THINK it's a Procomp dist. when i bought it, it had shipped with a Procomp coil, which I still have if anybody wants it as well.

 

[72 slopar]

35 shipped to 31605 and I'll take it.

 

[stroker_valiant]

35 shipped to 31605 and I'll take it.

Or 40 plus shipping to 31605?

 

[72 slopar]

No thanks. don't need it that bad.