draginmopars
Well-Known Member
What have you made ?
While running wires for the starter
I couldn't find the correct wire end I needed
Didn't want to buy a factory harness
I have a roll of wire, from a aircraft, that was used to run the APU
just need to crimp an end on.
wasted the morning, trying to find the right size> 1/2"
no one had anything, either to big or small
So, I went to the cooper scrap pile
Found a 1/2" copper pipe end
filled with solder, to end of wire,
crimped while still hot
then flatten remaining end
drill correct hole size, rounded edges
added a piece of heater hose for extra protection and support...
While running wires for the starter
I couldn't find the correct wire end I needed
Didn't want to buy a factory harness
I have a roll of wire, from a aircraft, that was used to run the APU
just need to crimp an end on.
wasted the morning, trying to find the right size> 1/2"
no one had anything, either to big or small
So, I went to the cooper scrap pile
Found a 1/2" copper pipe end
filled with solder, to end of wire,
crimped while still hot
then flatten remaining end
drill correct hole size, rounded edges
added a piece of heater hose for extra protection and support...