69Chrgr
Charger/Cuda
Does anyone have any pics of what they had to do for the steering column and a rack and pinion installation? I am using TTi headers for a coil over setup. Thanks as Always.
Steering Column Mods with Hemi Denny Coil Over Suspension
- Thread starter 69Chrgr
- Start date
-
Yea, I show a few pictures of my set up on page 23 of my build and also on page 25. Sorry I don't have much more detail of the setup.
I did away with the stock style column and grafted in a rav4 elc-power steering unit so I have a few u-joints on my setup one under the dash just before the firewall and the two in the engine bay. The HDK setup makes this fab east, and its strong enough to be used as manual setup as well as assisted.
1965 MMP's Barracuda Hemi swap! The Ever Changing Build
racerjoe
Well-Known Member
Denny provides instructions with his kit. Very easy to follow.
69Chrgr
Charger/Cuda
Thank you!
69Chrgr
Charger/Cuda
Excellent. Thank you!
loganscuda
This/These
I used a flaming river tilt column. If you take apart your original column the flaming river will slide inside the housing and you will be able to use the climb support and the floor support without spending all the extra cash. I will see if I have photos. I posted them before how I did it. Save a tone of money and kept all original mounts.
loganscuda
This/These
loganscuda
This/These
I did not use Hemi Denny but RMS I think they both use the same mustang II rack. I used the flaming river swivels reduced diameter no fitment issues.
loganscuda
This/These
69Chrgr
Charger/Cuda
Thank you LogansCuda!!!
-
Similar threads
