Stock cast iron intake height 2 brl-4brl ?

[rustytoolss]

I dont have any intakes to measure. But can anyone tell the height of stock cast iron dual plane intakes stock 2brl...and stock 4brl. small block engines.

 

[ir3333]

no measurements but the throttle bracket is about 1 1/2" higher for a 4 barrel intake

 

[Dana67Dart]

I dont have any intakes to measure. But can anyone tell the height of stock cast iron dual plane intakes stock 2brl...and stock 4brl. small block engines.

height from where?

 

[rustytoolss]

height from where?

From the end flat surface to the carb mounting flange surface....overall total height.

 

[Dana67Dart]

So if the intake was sitting on its heat riser heat shield from the table to the flat the carb sits on?

 

[rustytoolss]

So if the intake was sitting on its heat riser heat shield from the table to the flat the carb sits on?

sitting flat on table at the end gasket surface where the RTV is is used to seal to block..... to the carb mounting surface