I am thinking about making some subframe connectors out of small pipe.I saw some for sale on line somewhere[I can not find them now].I have access to free pipe at work.
I have 1.5 inch pipe double wall {3/16 inch thick]
I have 1.25 inch pipe single wall {1/9 inch thick}
The ones I saw on line were 2 pipes welded together side by side,box welded on rear,flat plate on front. I am thinking about going with the 1.5 double wall as a single pipe piece instead of welding the 2 smaller ones together [though the 2 welded would be ridiged]
I just dont know.Any of yall ever gone this route?
I have 1.5 inch pipe double wall {3/16 inch thick]
I have 1.25 inch pipe single wall {1/9 inch thick}
The ones I saw on line were 2 pipes welded together side by side,box welded on rear,flat plate on front. I am thinking about going with the 1.5 double wall as a single pipe piece instead of welding the 2 smaller ones together [though the 2 welded would be ridiged]
I just dont know.Any of yall ever gone this route?