super six kick down throttle lever

[hosehead]

Hey everyone, I'm hoping one of you could point me in the right direction. I have acquired a complete super six set up with the exception of the throttle pressure lever on the trans. Is this unique to the super six kick down or just the year of the 904 trans? And I promise I've looked for the answer prior to asking here. Lol.
Thanks all.

 

[junkyardhero]

if you're talking about the "candy cane" kick down rod, it's specific to the super six only.

 

[Bugman]

1974 and up are part number 3751551 standard slant and 318 all bodies see this thread Is this a Super Six Kickdown? - Page 3 - Slant Six Forum

 

[Bugman]

The angle is important throws lever forward ,rod is too short for straight lever ,lenght center to center of large holes 2.40 also important Is this a Super Six Kickdown? - Page 4 - Slant Six Forum

 

[Bugman]

Kickdown / TV Lever length and slot angle. - Slant Six Forum

 

[hosehead]

if you're talking about the "candy cane" kick down rod, it's specific to the super six only.

I’m talking about the lever on the transmission

 

[junkyardhero]

I’m talking about the lever on the transmission

thank you for the clarification. also, apparently i can't read otherwise i would've caught that! my bad.

 

[hosehead]

Kickdown / TV Lever length and slot angle. - Slant Six Forum

And thank you Bugman! I’ll post an ad for a 74 and later lever.
I appreciate the help!

 

[Bugman]

on the right 3751-551 2.40 between large holes on the left 2899370 727 tranny 2.61 between holes and beny wrong

 

[Bugman]

different angles and lenght

 

[Bugman]

on left shiny one bent to left 727 on right 904 bent to right this is done for clearance reasons

 

[Bugman]

727 goes up 904 goes down. they start in the same plane but change direction just past the small hole