tiny plastic retainers

[KramerSwinger70]

dnt know wut else to call em. those little pieces of plastic on the pins on an emblem. makes the emblem snap in place. i need like 4 of these for my "Swinger" emblem. anyone know what im talkin about an where i could find em? haha

 

[Steve68]

Is this what you are looking for? http://cgi.ebay.com/ebaymotors/Mopa...ptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

 

[KramerSwinger70]

no. ill try an get a pic 2day. its just a plastic tube that you push onto the pin onthe emblem. then u p[ress the emblem into the mounting holes on the body

 

[Burntorange70]

They can be had from Year One or other places like that. Look in the emblem section you will see them there. I have used them and have to say well they suck! What I would like to know is there any thing better than them out there that can be used?

 

[blue missile]

The answer is yes there is a better way, The 1 1/2" round retainers for duct insulation that fit over the welded on pins really work well, but you need to be able to get to the inside of the area to push them on.
Andrew

 

[Burntorange70]

The answer is yes there is a better way, The 1 1/2" round retainers for duct insulation that fit over the welded on pins really work well, but you need to be able to get to the inside of the area to push them on.
Andrew

Thanks for the tip blue. The other ones have to go on from the inside too so no big deal there as long as they work better. I hate them things.

 

[redrag64]

Try "R/T Specialties" - they carry all of the old trim tabs, clips, etc.