bobj
Well-Known Member
Will stock 904 converter cause 360 with 450 lift cam cause engine to stall in drive
Torque Converter
- Thread starter bobj
- Start date
-
Could if the the timing and carb had not been adjusted after the cam change.
AJ/FormS
68 Formua-S fastback clone 367/A833/GVod/3.55s
- Joined
- Jan 19, 2014
- Messages
- 25,055
- Reaction score
- 12,396
Only if it's defective.Or,What Lelo said.
More often than not, the devil is in the tune. So get your T-port synced up, crank about 20 Degrees initial into her with the V-can defeated, hook up the PCV, and try again.
More often than not, the devil is in the tune. So get your T-port synced up, crank about 20 Degrees initial into her with the V-can defeated, hook up the PCV, and try again.
fishy68
Tyr Fryr's Inc.
I agree with the above comments. One thing I'd like to ask though. Is the 904 converter properly weighted for the externally balanced 360? That won't cause it not to run but it will cause the 360 to vibrate itself to death
-
