Upper trim above the finish panel

[67barracuda]

Where do I get the bolts that hold the upper and lower trim on the trunk lid of a 67 barracuda. what have you used

 

[dgc333]

I have a 68 which uses a sliding brakect on the trim. Most all of the studs were broken. I ground them off and knocked out the remainder. I found a screw at the local hardware store that had a large diameter shallow head and tack welded these to the brackets.

Don't think you will find the actual fasteners that the factory used so you will likely need to use your imagination.

 

[Suregrip391]

Where do I get the bolts that hold the upper and lower trim on the trunk lid of a 67 barracuda. what have you used

Laysons sells the correct clips and so does Jims......I am not sure if the one below is the correct size but this is what ytou are looking for.....

 

[Jim Lusk]

Check with R/T specialties. They are the supplier of most of these clips. I hear he's a little hard to get ahold of these days, but he's at most major shows.