Used diamond Pistons

[-Sledgehammer-]

Diamond pistons set of 8... these were out of my engine that had trash go through it.... they are 4.500" -22cc. Just listing them if someone has a need for them on anything! make me an offer and I accept paypal...... Ill just put a price of $200 cause ya have to have a price so mods wont delete! pm me :thumb:

 

[RustyRatRod]

I'll go 0.60 a pound. That's the goin rate on aluminum. With skirts like that, I wouldn't use um for anything else.

 

[pishta]

Knurl 'em old skool...if you can find someone to do it. Hey, if you run a period correct rat rod, might as well go all the way!

 

[-Sledgehammer-]

ill ship em to ya and if you dont likey Ill refund your cashola... im sure someone can clean them up... :cheers:

 

[RustyRatRod]

Well.....honestly, I reckon you could polish um up, and hone the cylinder to fit. I speck that would work fine since the skirt is where the clearance is measured anyway. Hell, if I was buildin a race only motor, I wouldn't hesitate. Is that one the worst lookin skirt?

oh...and were you acceptin my 0.60 a pound offer?