WANTED: OD 4 speed bellhousing

[piercegwynne]

Hello, I am in need of a bellhousing for my transmission. I am looking for a 10.5" aluminum small block bellhousing with the casting number 3743859 and a bearing retainer hole opening 5.125" let me know what you got! Also I'm looking for a 10.5" 130 tooth 360 flywheel.

 

[Idaho]

bump for ya

 

[Inertia]

I've used a couple of these flywheels, good dollar value $150..

http://store.440source.com/1045-Billet-Steel-Flywheel-New/productinfo/113-1014/

hope it helps

 

[discharger1332]

i have a o/d bell, not sure of its casting number but i can check it tomorow. i will be heading up to fresno for thanksgiving.

 

[RustyRatRod]

That's not an OD bellhousing. That's for an NP435. The A833 will not bolt to it.

 

[Tbone416]

That's right !!!!!

 

[discharger1332]

wow, thanx for the heads up. it came in a bunch of parts years ago. never had an o/d set up. or np435 for that matter. thanx again.

 

[highflyer]

look on sac and sf/bay c/l..fella has one there although ha want s a little fore it..j

 

[RustyRatRod]

You don't HAVE to run the OD bellhousing. You can run a regular 4.80" hole small block bellhousing as long as you put a 4.80" front bearing retainer on the transmission. It might be cheaper that way.

 

[trapster]

There have been a few on ebay

http://www.ebay.com/sch/i.html?_trk...TRC0.X3743859&_nkw=3743859&_sacat=0&_from=R40

 

[RustyRatRod]

That's not bad. I wouldn't sell mine for that. lol

 

[trapster]

it is less than I paid a few weeks ago. I paid 220 shipped, but it was already beadblasted
then another 30 to brewers for the correct pivot.