what does the hand break relay switch do?

-

2kids

Well-Known Member
Joined
Jan 10, 2010
Messages
380
Reaction score
2
Location
Washington State
What does the hand break relay switch do?

71 Dart swinger
 

Attachments

  • upload this one.jpg
    132.6 KB · Views: 136
When E brake is set brake warning light on dash should be lit. This is what switch controls.
 
YUP. There has been countess ruined brake shoes and damage to cars because people left the parking brake applied, ruined the brakes, and could not stop

"Back when," my Grandparents owned two Chrysler products (early 50's) with "fluid drive." First my Grandma would leave the brake on (drum on the driveshaft) and ruin the parking brake. Then, next time around, there would BE no brake and the car would roll when parked. She ran one off a 20' bank at the neighbor's driveway and wrecked that one, the other rolled down a steep hill.

AND she darn near burned one car to the ground when she drove down the road, brake on, and the brake and grease under the car caught fire. There was a pond nearby, and a passing neighbor honked and got her to stop, then ran her car down into the pond!!!!

Was she a poor driver? YES

Would a great big warning light have helped? Maybe
 
That car had a brake band that tightened down on a disk attached to the end of the transmission, and not connected to rear brake components. It was not uncommon to get them hot enough to start a fire. Also when parking these cars that had fluid drive, one was required to set the parking brake to keep it from rolling off into the sunset.
 
-
Back
Top