1974DartSport
Senior Member
My 74 Dart Sport sat for fifteen years and the right front fender was very rusted, so I bought a new fender from an Arizona no rust 73 Dart Swinger. As I instructed, the body work and painting were completed with the "Swinger Emblem" holes filled in, so now I have a new paint job without holes to mount my "DART" and "Sport" emblems. (The left front fender "DART" and "Sport" emblems are installed.)
What size drill bit do I use to drill the holes for the new emblems? Do I drill from the outside (paint side) or from the inside. Somebody told me to place a small block of wood on the metal and get a good start in the wood and keep going until you punch through the metal. All help is appreciated. I do not want to scratch the paint.
Do I need a special type drill bit?
What size drill bit do I use to drill the holes for the new emblems? Do I drill from the outside (paint side) or from the inside. Somebody told me to place a small block of wood on the metal and get a good start in the wood and keep going until you punch through the metal. All help is appreciated. I do not want to scratch the paint.
Do I need a special type drill bit?