What measurements before front end rebuild?

[Kllrbee]

Hey guys,
Before I start tearing the front end apart, what measurements are necessary?
LCA pivot point to bottom of spindle?
Center of wheel opening?
What else?

Thnx

 

[67Dart273]

Maybe ride height if you are happy with that and that is convolute in the service manual, I would document that any way you feel is accurate and repeatable.

 

[Kllrbee]

Ok thanks.
I know that after reassembly, ride height is first to set. Then play with caster, camber, toe and get close enough until I get to my alignment shop.

Guess its not as crucial for disassembly. Ill take some base measurements and pics for reference.

Thanks again.

 

[moparmat2000]

Make sure if using rubber LCA bushings to NOT tighten your LCA pin nuts on the K frame until the car is on the ground and at the ride height you want it at.