What year dash is this?

[bb66cuda]

I’m swapping the dash out of my 68 Dart for one that I believe is out of a 68 or 69 Barracuda. I would like to know what year it is so I can get the correct dash pads.

 

[junkyardhero]

the thumbwheel cutouts say 68/69

the holes in the lower frame lip for mounting the lower dash pad say 68

 

[Mopar Momzee]

68 looks like there’s holes for the lower dash pads

 

[bb66cuda]

So 68 was the only year that had the lower dash pad?

 

[junkyardhero]

So 68 was the only year that had the lower dash pad?

correct

 

[HemiSSDart]

Yes it is a 68 dash, your pads will bolt on...

 

[oldmopardude]

You should look over the wiring harness between the two, as the dart has different connection in the back than the barracuda, at least the two on my barracuda and dart aren't the same.different types of gauges,,,,,

 

[bb66cuda]

I haven’t looked closely yet, but would the 2 dash frames have the same cutouts or would it be different where the gauges are? Unfortunately I don’t have AC either so I’ll probably have to find a non AC rally bezel.

 

[junkyardhero]

I haven’t looked closely yet, but would the 2 dash frames have the same cutouts or would it be different where the gauges are? Unfortunately I don’t have AC either so I’ll probably have to find a non AC rally bezel.

the rally and standard dash are different cutouts for the gauge clusters.

the wiring attachments at the gauges is totally different as well.

 

[oldmopardude]

same applies between 68-70 coronet and charger, not interchangeable.

 

[HemiSSDart]

Yes you must get the IP wiring harness for the Barracuda dash, and the correct IP insert without A/C...

 

[bb66cuda]

I have the entire under dash wiring harness from the barracuda also, would it be possible to just use it instead of the dart harness?

 

[Mtrhead]

Yes

 

[bb66cuda]

The harness going to the tail lights is a little different on the barracuda harness also.