Will these Fit???

[My70b]

I have a 383 hp block 1970 date code. The heads that were on it are 906s. The block was bored .030 over with flat top pistons I would just like to freshen it up new rings,bearings, ect. Block, pistons,crank all look very clean the problem is the heads were taken off and sitting a while in a shed verses the garage the block was in, so the heads are all rusted and need to be redone. The prices range from 475.00 to 750.00 to redo them a little pricey for my budget. Someone i know has a set of heads he just took off a 440 went with aluminum ones the casting numbers are 3751213 and 3769902 these have less then 2500 miles on them best part he only is asking a 100.00 for them and said they would bolt on and go. Im not building a race motor just a driver. Is there any problem using these heads? Any special gaskets? parts? needed. And if they are good what size cam would you's use? My first motor redo so be kind if I dont know all the technical terms. Thanks Gene

 

[My70b]

Is this that dumb of a question? Just trying not to get taken advantage of by buying these heads. thanks:???:

 

[70aarcuda]

http://www.mymopar.com/headcastnumb.htm

yes..they will fit...,

 

[My70b]

Thanks are there big differences between these and 906 heads?

 

[Kernel Sanders]

For general stock performance use, there wont be any noticable difference between the 906 heads and the later heads. One plus side, the 3769902 heads *may* have induction hardened seats.