wrench Size

[66GTDART]

I can’t remember the size of the wrench to tighten the large bolt that holds the oil filter angled adaptor to the block. due to the headers I’m going to have to come up with a modified wrench to tighten the bolt so I don’t have to remove the headers.
Thanks in advance!

 

[junkyardhero]

1-3/16"

or at least that's the size of the one i have here on my bench

there is also a smaller one that is 3/4"

 

[66GTDART]

1-3/16"

or at least that's the size of the one i have here on my bench

there is also a smaller one that is 3/4"

Thank you! Mine appears to be the large one by feeling it.

 

[junkyardhero]

Thank you! Mine appears to be the large one by feeling it.

just for S&G's i checked an aftermarket bolt that i have here.

it's 1-1/4"

so i'd measure before modifying

 

[66GTDART]

just for S&G's i checked an aftermarket bolt that i have here.

it's 1-1/4"

so i'd measure before modifying

just for S&G's i checked an aftermarket bolt that i have here.

it's 1-1/4"

so i'd measure before modifying

 

[66GTDART]

Will do, Thanks U!

 

[MOPAROFFICIAL]

The Crescent wrench is your friend

 

[junkyardhero]

The Crescent wrench is your friend

ah, the venerated "all 16ths" a critical part of any mechanic's arsenal!

 

[go-fish]

The Crescent wrench is your friend

The good old adjustable hammer.

 

[33IMP]

The (insert nationality slur here) socket set.

 

[66GTDART]

The good old adjustable hammer.

The (insert nationality slur here) socket set.

Both would work if i could get pass the headers!

 

[Demonx2]

The Crescent wrench is your friend

Just be sure it's a metric crescent wrench!

 

[middleagecrisis]

Whatever size it is will be the one I don't have or have lost in the shop!

 

[66GTDART]

Just be sure it's a metric crescent wrench!

I got a brand new one!
But it won’t fit behind the headers!