WTB: V8 K member for my duster

[jeremy2146]

Looking for a small block V8 K member for my 76 Duster. I dont know whats going on but I'm thinking mine is a /6, cause the top of the drivers side mount it trimmed, there are washers on both sides and the drivers side just touches the engine block, and it has a 318 in it. Gonna run some numbers tonight and see if it was a /6 car. Really want to make this right!!! I had rigged up stuff!

 

[1970Duster]

A picture would help and which K frame are you looking for Biscuit or Spool mount (Spool mount is the better of the two).

 

[Bulldozer]

the fifth digit of the vin will tell you

 

[airgrabber]

See here for a factory small block v8 k frame for sale... http://www.forabodiesonly.com/mopar/showthread.php?t=184571

 

[jeremy2146]

I will try to get a picture of it on here tomorrow, pretty sure its a spool tywpe though

 

[jeremy2146]

Yep, its a C car....so /6 original....I'm leaning....lol....looks like they used some adapter motor mounts for it but something is still a little off. I'm posting some pictures....

the fifth digit of the vin will tell you

 

[jeremy2146]

So here are som pictures.....I found that it is an original /6 car and it is obvious now after some research, but you would think the adapter mounts they used would fit a little better.....just poor setup....definately going to put a V8 K member in it....is there anything else I will need to change it over....It looks like the steering will be fine...but this my first Mopar.

 

[jeremy2146]

Got it here, and got it in. Much better!!