Recent content by vkute265

yeah mate oil cross fits the motor was running in the car until i pulled it out to check over it and found my mopar cam stuffed. i had to grind the bottom of my super victor for it to clear the magent and vacuum idea was in the back of my mind. i guess i wont know until i get the cam and...

here is my block, i havent ground anything yet but its been mentioned before how much has been machined around the lifter/pushrod area

i bought the cam and lifters as a kit, i dont have them yet but there on there way from the USA. wont see them for another week or so.

spewing my bottom end is already together it was running in the car, but pulled it out and decided to go a roller cam.

im looking to use methanol on my 318 stroker when i goto the drags motor should put out 550hp with the new solid roller currently run a 850dp race demon i run a rci fuel cell -8 an hose from tank to a holley hp 125 pump then -8 to a reg then -8 to the carb i am thinking about getting a 950 dp...

ive just purchased a comp solid roller and lifter kit im just wondering who has used the 828-16s and where they any clearance issues or block grinding cheers Ash

Value for money would have to be the airwolfs i read about today http://www.moparmarketforum.com/forum/viewtopic.php?f=11&t=27883

sell them and get some edelbrocks lol:burnout:

couple of vids too ay QIK 318 VS MILTON'S E55 SIDE BY SIDE 11.60'S - YouTube QIK 318 FIRST RUN AT MOPAR SUNDAY 2012 SMOKE SHOW - YouTube Ash Lakeside 2 9 12 - YouTube (dont mind the commentry lol) Ash Vs Centura - YouTube

hey guys a bit of an update, in street trim pipes on the ute has run 12.30 at 110. street trim, pipes off carb jetted to suit its run 11.57 @ 114. with a best 60 foot of 1.58. heres a pic from a couple weeks ago where it was running 7.30's all day and 1.60 60 foots at a local 1/8th mile track...

thanks for all the votes, the more the merrier

7.5". ball and cup. the stroker has ally heads and 11.7 comp, so it uses the cam. its not just there for the sound. 1.6 rockers makes it around .590 lift

I got one in my 318 stroker, with 1.6 rockers, sounds good goes hard, runs 11.65 in a vk ute

got the ute fired up again today and run the cam in, sounds good, see how it goes at the track in a couple of weeks. should be fun. cheers Ash heres a short vid after we ran the cam in, dont mind the smoke its the paint on the headers. petes vf ute408 - YouTube

Thanks everyone for the votes and the comments. Yeah the motors are offset makes it hard to do oil lines and headers, I know a few blokes shift there motor across to the middle for more room to do headers Cheers Ash