Search results for query: *

Surface rust on back side,I’ll send a pic tomorrow

$100 would be fine for the hood

For Sale,make offer. Located in Baltimore County. Pick-up only. $100 for the hood, $40 for the bumper

The back spacing is 4.125", thinking the 1/8" difference is not a biggie. Thanks for your help.

So, I bought 7" x 15" Cragar's with 5/4 bolt circle and 245/15 BF Goodrich tires for the rear. I had to back-order 6" x 15" Cragar's 5/4 bolt circle and 205/15 tires for the front. Just received an email saying Cragar is no longer making the 6" x 15" in a 5/4 bolt circle yet it appears they...

Yes

No, the one I need is only about 10-12" long and goes from the condenser, through the core support and into the drier canister. I think another guy has one. I'll get back to you with a picture if that falls through. Thanks

Ok,thanks. I'll get it from another guy. Thanks anyway.

Any luck on the a/c line? Someone send has one if you can't find it. Thanks

I don't know, probably, I'll have to check.

Ok thanks

I need the steel line that goes from the condenser to drier. Must have good threads on both ends.

I'll take em. Send amount and PayPal info. Thanks

Photo attached of clips neede for door linkage. Can't find anyone that sells them new. Thanks

Need 2 clips that go onto the short "s" shaped piece of door linkage / rod.

Will do,thanks

Let me know when you can. Thanks

And reverbs were out in the early 60's

Needed for both sides, must be in very good condition. Thanks

Have one off a 69 Dart Swinger, $300 Located in Maryland though

Reverb for radio

Is there supposed to be a aluminum or stainless trim piece on top of the doors and at the quarter windows where it meets the glass channel?

I'm in the process of a complete restoration of a 69 Dart Swinger. K-frame , motor and transmission have been reinstalled. When installing torque shaft linkage rod to the transmission and the bracket that gets bolted to frame rail, the torque shaft is not straight across. It runs downhill from...

The fenders were removed by someone else, then the car (69 Dart Swinger) went to the paint shop. I bought new metal splash shields and rubber gaskets that go behind both front wheels. At the same time a "C" shaped gasket was listed as a "fender to body gasket" and as a part I needed. The...

Speedometer starting going wacky, needle jumps all over the place. Would this most likely be the transmission gear? Thanks

nope, oil plug is in; plenty oil to right rockers just none to the left. Thanks, Tim.

Thanks Tony, I'll give it a try, easy enough.

The oil hole goes thru the stand and angles past the head bolt. I measured the distance from the stand to the top of the lifter, added for the lifter height and found the length of wire I could feed down was the same. Not quite sure where else the wire could have been going except down the oil...

Thanks for your reply. I've rotated the motor 20* past tdc after the compression stroke of #6 cylinder, (the location where there should be oil going to the left rockers) and turn pump with a shaft and drill. No luck, must be either cam bearing or possibly faulty cam, (holes not drilled all the...

Will check it again, can't hurt. thanks