Search results for query: *

who has 2 bolts for front shocks bolts 7/16x14x2 1/4 with 1 1/2 shoulder i can get . Cant buy at hardware store

Not the same . The shoulder of the bolts are shorter

Where can i buy lower front shock bolts for my 70 Duster? 7/16 x 14 x 2 1/4 with a 1 1/2 shoulder

Put leaf springs on my 70 Duster can anyone tell what to torque the shackle bolts,ubolts and the bolt in the front of the springs I believe they call it the pivot bolt to

Any one know if that would cause bump steer

Would having your suspension height to low Cause bump steer

A question was asked by keystone if you run radial tires what would be your ride height higher or lower compared to factory specs

When they refer to adjusting blade are they meaning the bottom of the housing where the torsion bar goes in the lower control arm. Anyone have a pic of the adjusting blade

Where can you get the tool bodyperson

Thanks for all the info.Hard to get measurement on ball joint to floor because of inside of rim

I am still confused on where to take the measurements. Can not find any good pictures.

Thanks for the info

Where can I get torque specs for the front suspension on a 70 duster

Does some one have a close up photo of where to take the measurements for ride height on 70 Duster. Is it from the lower ball joint to floor and adjusting blade to floor. Then subtract the two. What are they meaning by adjusting blade

Do you need to use the washers

Can some one tell me what the ride height is on a 70 Duster . Has 15 inch tires .I am getting what they call bump steer under heavy acceleration. Going to check ride height and re align . Also installing different bushing in upper control arms to get more adjustment.

Where can I get the tubular control arms if I decide to go that way

I am running radial tires do I use this chart

who sells them

Taking my Duster to have it aligned . Any know what the specs are on the alignment. Also would changing to tubular upper control arms give me more camber?

Got mine reconditioned at steer and gear in columbus ohio.Did a really good job

I can not get any washers on the top or bottom of the bushing.I think i just did not have the bolt tight enough.Do the washers have to be in there? I am sure it was not torqued at 60 before.I had another idler arm an placed it in there an tightened it without any of the linkage hooked up and...

I also noticed that the bolt that goes through the bushing has slop in it letting the idler arm move when turning the wheels

The idler arm i purchased came with two felt washers and a metal flat washer.Does the flat washer go on the top or bottom of the idler arm when installing the bolt through the k - member Or should they be two flat washers one on top one on bottom.This is for a 70 duster small block

Can anyone give me some help with this?

I have the hood hinges off of my 70 duster. I have a set of new low tension springs that i have installed but they will not hold the fiberglass hood up.Is there a tool or procedure to put these springs on to make sure they are wound tight enough so as to give me more tension so they work...

Mine is manual if i change the ratio do i have to change pit man arm.It is a 340 with tti headers

The steering box on my 70 duster has a lot of play.I am looking into where to have it rebuilt and maybe change the ratio.Has anyone went to the different ratio and how do they like it or should just stay with the original ratio.Any info would be appreciated

Have to turn in for the night have to get up at 4 am for work will check back in tomorrow Thanks for the help