67dartgtgo
Well-Known Member
Damn that's a good looking buzzin half dozen!
you mean i need a single -pick up distributor to install single pick upNo, you need a single-pickup distributor.
my car did not come with lean burn system on it .It will fit, but the dual-pickup distributors are for the Lean Burn setup, with timing controlled (badly) by a primitive computer your vehicle doesn't have. Most people with Lean Burn who want their cars to run well ditch the Lean Burn and install (wait for it) a single-pickup distributor with vacuum advance.
I was going to say thanks¯\_(ツ)_/¯
Get your confusion about ignition systems solved by starting a new thread (this one is about fans). Make sure you state the year and model of vehicle.
i just got that fan clutch in today , it really doesn'tSee here and here (on that page you can read up on the Toyota Land Cruiser fan and clutch — then go pounce on this ridiculously inexpensive one)
i just got that fan clutch in and is too tall will rub on rad . are you sure of the applicationThe linked one was from an '88 Toyota Land Cruiser with the 4.0 engine. Should be '80-'89 Land Cruiser.
you must have used another model that the one on ebay , because it wont work , way too bigI ran the setup described in the second "here" link you quoted in my '73 Dart for awhile. Didn't measure.
you must have used another model that the one on ebay