Stop in for a cup of coffee

-
73 dart custom said:
My sis has a car supposed to have one. I have been looking for a picture of where a hand squeeze one would be on the inside. Not seen one yet.

Thanks! Purchased her last month!
Click to expand...
usually on the floor upper left the ones I have seen. They do make repops of them.
 
Rainy Day Auto said:
I am guessing by your user name that it's a 73 ?
Click to expand...
Yes she is. So far we have replaced fuel pump, ballast resister, torsion bar, plugs and wires,
and electronic ignition control module. Next will be the bushings for the wipers and hopefully that will get her on the road again.
 
They look like this. Simple and cheap to produce.
washer.jpg
 
73 dart custom said:
Yes she is. So far we have replaced fuel pump, ballast resister, torsion bar, plugs and wires,
and electronic ignition control module. Next will be the bushings for the wipers and hopefully that will get her on the road again.
Click to expand...
Do the wiper pivot seals when you are in there easy and cheap insurance from a leak.
 
halifaxhops said:
Do the wiper pivot seals when you are in there easy and cheap insurance from a leak.
Click to expand...
I have never done the bushings or seals. I don't do well up under the dash any more. I can't see much with my bifocals and I don't bend as easy as I did when I was younger. LOL
 
73 dart custom said:
My sis has a car supposed to have one. I have been looking for a picture of where a hand squeeze one would be on the inside. Not seen one yet.

Thanks! Purchased her last month!
Click to expand...
Never seen a hand squeezed one but a couple of dads 1940s military vehicles have hand operated levers for the wipers
 
halifaxhops said:
Any HVAC guys here? I need to find just the ceramic insulators for the electrodes for a test set any ideas where to just buy those? 4 1/4 long, need four of them.
Click to expand...
My family ran an HVAC business for 40 years before my grandfather retired. My brother is a licensed hvac tech still, I'll ask him but likely you'll have to either find an online dealer or a hvac distributor store
 
toolmanmike said:
I have never done the bushings or seals. I don't do well up under the dash any more. I can't see much with my bifocals and I don't bend as easy as I did when I was younger. LOL
Click to expand...
Me ether Mike, plus when I get up the earth starts moving :lol:
 
Speaking of ladders the guy I got the shelves with owns a farm junkyard, he came over to deliver mine yesterday and mentioned he has a two man scissor lift I can borrow to put the ceiling up in the shop!!!!!!!!!
 
I used to be ok with ladders and heights until I slid down a barn roof years back. North side, moss covered cedar shake shingles. I dug my fingertips in and stopped a few feet from the eave. I was shaking like a dog pooping peach seeds!
 
halifaxhops said:
Speaking of ladders the guy I got the shelves with owns a farm junkyard, he came over to deliver mine yesterday and mentioned he has a two man scissor lift I can borrow to put the ceiling up in the shop!!!!!!!!!
Click to expand...
Score!
 
Heights never bothered me in the navy I was the guy that used to paint the antenna and radar masts now that is a trip underway! Now I just cant deal with it with the dizziness.
 
Have to run going for load two of shelving and a ton of pegboard a full pallet of it to bad my walls are full!
 
You must log in or register to reply here.
-

Back
Top