It is on Facebook market place....Let me see if I can link it...
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Unconventional
Well-Known Member
Coffee consumed, time to go make final preparations for the trip south to Oceanside. LA traffic beware! Hillbilly with a Hemi will soon be on the road! 
Almost done.
Starter replaced, have to tie car down before cranking though,as it spins engine so fast car tries to flip over. Owner had a service booked for next week, will do it while its here.
Starter replaced, have to tie car down before cranking though,as it spins engine so fast car tries to flip over. Owner had a service booked for next week, will do it while its here.
Chipper is alive again. Trimmed the varmint chewed part off the chute. Notched the top corners and the taper worked near perfect to bolt to the outside instead of inside as it was originally. Hopefully the inside edge is not too much of an obstruction for branches going in. I did see a busted bolt underneath where the base of the chute attaches. Looks like major disassembly to change it. But it is secure with other 2 bolts, and looks like its been that way for a very long time. So not going to worry about it.
Wow! 4 in a row… you didn’t have that many before did you? Oh, wait… that’s across the row from where you were.
That’s it! Im done.
Just as well, i’m hurting again. Wish this would go away. Time to visit doc again.
Just as well, i’m hurting again. Wish this would go away. Time to visit doc again.
Can’t wait to see a view like this more often, only with open road in front
Im taking a week off to get the Fargo done. If its ok with my wife.
I sure hope so.
I’m planning on doing the same now that I have to go back to full office work on Monday.
-
