I have a Hemi Denny front end in my 68 Cuda, and love it! What do you guys use for front end alignment specs. I don't do any road racing just normal street driving. Also it is power steering.....
Here is a 588 cubic inch RB motor in my 68 Cuda street car. This this would be just as easy to work on as a small block. It all depends on how you do it.....
The whole exhaust , headers and all was about $7,000. It's all stainless steel made with v-band clamps. I don't have side pics, but here are a few. They fit really well!
Sorry my reply did not show on previous post. I have an RB in my 68 Cuda. I went the custom header route, just for that reason so I can get at the plugs. It doesn't get any better than this for an RB into an A body......
I ended up going with an AAR hood. Turns out I needed the larger 5 "scoop. I went with AAR because they can have it to me in a week. I will post pics when I have it on the car should be soon
On my 68 cuda, I have a 588 rb motor in it. No way it will fit under the stock hood. I see you can get a fiberglass one with a super stock scoop. They have 2 sizes of scoop. One is 5" tall and the other is 4".
My motor has an indy 3x with a dominator. Does anybody run a similar combo? Need to...