Recent content by 340 mopar

I want to go through traps at 6700 to 7000 rpms. Where do you think the 29 inch tire will put me at rpms

what size tire should i run? i can fit 29/12.5/15. mini tubbed. about 450hp i think. 1970 scamp, 3500lbs,340- 10/5 to 1, pop-up hyperu, closed chambered heads (thick gasket) air gap intake, 750dp, lunati solid cam 60433, ported heads from brian. shift at 6700 to 7000. 430 posi 8 3/4, 727 reverse...

on my 340, stock rods, there is a hole about 1/16th of an inch in the bearing where the two half bearing shells come together. It goes through side of rod by bolt. I think this is to oil cylinder wall. Do you think i should use bearings with or without this hole. Have clevit 77 now with hole...

when installing caps do the notches in bearing cap and rod go on opposite sides, not top and bottom? thanks

what a body where you trying these on? whats shipping to 99212, spokane wash?

Thanks, Now I can finally order it. thanks again Gary

My 1971 scamp 2 door, has 5 bows. Nobody lists scamps in their headliners. Can anyone tell me what to order? Dart, Valiant, swinger? thanks Gary:banghead:

looking for 2 - 5x4 1/2 bolt pattern 15x10 with 6 1/2 back spacing. Going under 71 scamp, mini tubbed. Thanks Gary:burnout:

whats shipping to washington state 99212

what is back spacing on 15x10s

what is the back spacing on 15x10?

Does any one know if hughes has caught up with their back orders? How long of wait, if any? Are they doing the tooling or did they hire another shop? Thanks:D

Can I hot tank block after installing copper tubing for oiling mods for lifters? Will the acids eat the copper? Thanks:banghead:

bump

welcome from sunny spokane